Alpine SBV-10-WRA 10-Inch Subwoofer for 2007-2018 Jeep Wrangler with S-A60M Amplifier, wire kit and bass knob

Alpine SBV-10-WRA 10-Inch Subwoofer for 2007-2018 Jeep Wrangler with S-A60M Amplifier, wire kit and bass knob - This bundle includes the Alpine SBV-10-WRA Pre-Loaded 10-Inch Subwoofer for 2007-2018 Jeep Wrangler JKU, the Alpine S-A60M Mono Digital Subwoofer Amplifier, Alpine RUX-KNOB Remote Bass Knob, relevant wiring, and an Alpine coozy.

Alpine SBV-10-WRA Pre-Loaded 10-Inch Subwoofer for 2007-2018 Jeep Wrangler JKU

10-inch subwoofer pre-loaded into a sealed, custom-fit enclosure
Designed to be pressure fit under the front passenger’s seat rails, no mounting hardware is required
Trail Ready - Rated at IP66 for protection against total dust ingress and water from any direction
OEM-grade weather resistant Molex 2-pin connector with pigtail wire harness
Nominal Impedance: 2 ohm
Frequency Response: 45-200Hz
The 300W RMS/900W max power rating is a match for the KTA-30MW Mono Tough Power Pack Amplifiers
Alpine S-A60M Mono Digital Subwoofer Amplifier - 600 Watts x 1 @ 2-Ohms & 330 Watts x 1 @ 4-Ohms

The S-Series amplifiers were designed to perfectly complement the already established and loved S-Series speaker and subwoofer line that Alpine Electronics has continually improved for years.

The S-Series Amplifiers have a diagnostic LED located behind the blue Alpine Jewell on the top of the amplifier. A Blue light means the amplifier is operating normally. A red blinking light means the amplifier is currently too hot for operation and needs to cool down. A solid red light can mean three things; 1. Amplifier circuit is abnormal. 2. Temperature is too high. 3. Power supply voltage is too high.

Alpine RUX-KNOB Remote Bass Knob

With the RUX-KNOB installed inside the vehicle cabin, easily adjust the bass gain of your amp while seated inside. Control multiple amps from just one RUX-KNOB controller – with the use of simple telephone cord adapters (which are readily available at many retailers).